| |
|
Workstation and Wrist Strap Monitoring Continuously monitor your ground connection to ensure ESDS products handled are safe Are continuous monitors a requirement of S20.20?
Note: Work surface must have a conductive layer such as Dual Layer Rubber or Dissipative 3-Layer Vinyl or Micastat® Dissipative Laminate with conductive buried layers. Our Continuous Monitors are not recommended for use with homogeneous matting.
|
| |
|
- Alarm signal status
Used to connect to light tower; allows additional workstation status
- IEC replaceable
Allows easy cord installation and replacement
- Verifies proper wiring of AC outlet and ESD ground integrity
- Ensures electrical ground, operator ground, and mat circuit are all grounded to the same potential
- Two pin terminal block
Allows user to monitor and ground worksurface table mat or laminate worksurfaces
- Provides continuous monitoring of:
1) One user wearing a wrist a wrist strap
2) ESD worksurface
3) Electrical ground
- NEW
Mat ground connection for grounding and verifying resistance of mat to ground
- NEW
IEC power connector
- NEW
I/O port for setting up relay to turn a light tower on and off when monitor is passing or failing
- Stand-by parking snap
- Hook and loop fastening supplied
- Provided with calibration to NIST traceable standards
- Provides true 100% continuous monitoring
With reliable wave distortion technology; no false alarms
- Worksurface resistance: 10 megohms
- Includes elastic wrist strap kit
- 5-Year Limited Warranty
- To see in-use picture of EMIT’s Full Time Continuous Monitor, click here
- Made in America
Note: Continuous Monitors pay for themselves improving quality, productivity, eliminating wrist strap daily testing and test result logging. Per ESD-S1.1 paragraph 6.1.3 Frequency of Functional Testing "The wrist strap system should be tested daily to ensure proper electrical value. Daily testing may be omitted if constant monitoring is used."
Per ESD Handbook TR 20.20 paragraph 5.3.2.4.4 "Typical test programs recommend that wrist straps that are used daily should be tested daily. However, if the products that are being produced are of such value that knowledge of a continuous, reliattble ground is needed, and then continuous monitoring should be considered or even required."
Note: Work surface must have a conductive layer such as Dual Layer Rubber or Dissipative 3-Layer Vinyl or Micastat® Dissipative Laminate with conductive buried layers. Our Continuous Monitors are not recommended for use with homogeneous matting.
|
|