• Provides 12 groundable points
• Six banana jacks and six 10-32 screws with split washer
  Provide numerous groundable points for wrist straps, carts and other items
• Includes one 6' long ground cord terminated with 0.200" ID #10 ring terminal 
  Allows easy attachment to equipment ground
• Includes mounting hardware
  One 10-32 x 1.75" socket headscrew with split washer and nut
• Easy to install
  Just drill hole through table top or leg and tighten nut to secure
• To see multi-grounder hub in use, click here
• Made in America

NOTE:

Per ESD 6.1 "Provisions may be made to include a resistor where it may be required for a purpose other than ESD."

ESD Handbook TR 20.20 paragraph 5.1.3 Basic Grounding Requirements "The first step in ensuring that everything in an EPA is at the same electrical potential is to ground all conductive components of the work area (worksurfaces, people, equipment, etc.) to the same electrical ground point. This point is called the common point ground. The next step in completing the ground circuit is to connect the common point ground to the equipment ground (third wire, green)"

One Megohm resistor is required in wrist straps, however, the recommended practice is hard ground per ANSI/EOS/ESD S6.1 that is no resistor between the common point ground terminal and a worksurface floor mat, or shelving. Per ANSI/ESD S20.20 Table 1 Grounding System Technical Requirement, the Recommended Range is less than 1 ohm AC impedance.