• 10mm Stud snap
  Compatible with mats that have a 10mm Socket snap
• Four banana jacks
  Provide four grounding points
• Compact design fits neatly under bench top
  Does not use valuable work surface space
• Ring terminal at end of cord
  Allows easy attachment to building ground
• Per ANSI/ESD 56.1
  No resistor is recommended but with resistor is acceptable
• Pair of mounting holes with two #10 screws
  Allow unit to be securely installed to workbench
• Included extra ring terminal
  Provides for customizing cord length
• Made in America

NOTE:

Per ESD 6.1 "Provisions may be made to include a resistor where it may be required for a purpose other than ESD."

ESD Handbook TR 20.20 paragraph 5.1.3 Basic Grounding Requirements "The first step in ensuring that everything in an EPA is at the same electrical potential is to ground all conductive components of the work area (worksurfaces, people, equipment, etc.) to the same electrical ground point. This point is called the common point ground. The next step in completing the ground circuit is to connect the common point ground to the equipment ground (third wire, green)"

One Megohm resistor is required in wrist straps, however, the recommended practice is hard ground per ANSI/EOS/ESD S6.1 that is no resistor between the common point ground terminal and a worksurface floor mat, or shelving. Per ANSI/ESD S20.20 Table 1 Grounding System Technical Requirement, the Recommended Range is less than 1 ohm AC impedance.