• Wrist strap parking station on unit
  Allows operator to hang wrist strap when leaving workstation
• Two banana jacks
  Allow for two people to ground wrist straps
• Ring terminal at end of cord
  Allows easy attachment to ESD ground
• Mounts under the front edge of workstation
  Saves work space
• Two "parking studs"
  Prevent accidental damage to cord when not in use
• Extra ring terminal included
  Allows for customizing cord length
• To see bench mounted ground in use, click here
• Made in America

NOTE:

Per ESD 6.1 "Provisions may be made to include a resistor where it may be required for a purpose other than ESD."

ESD Handbook TR 20.20 paragraph 5.1.3 Basic Grounding Requirements "The first step in ensuring that everything in an EPA is at the same electrical potential is to ground all conductive components of the work area (worksurfaces, people, equipment, etc.) to the same electrical ground point. This point is called the common point ground. The next step in completing the ground circuit is to connect the common point ground to the equipment ground (third wire, green)"

One Megohm resistor is required in wrist straps, however, the recommended practice is hard ground per ANSI/EOS/ESD S6.1 that is no resistor between the common point ground terminal and a worksurface floor mat, or shelving. Per ANSI/ESD S20.20 Table 1 Grounding System Technical Requirement, the Recommended Range is less than 1 ohm AC impedance.