•  10MM Stud snap
  Compatible with mats that have a 10MM Socket snap
• Two banana jacks
  Allow for two people to ground wrist straps simultaneously
• Ring terminal at end of cord
  Allows easy attachment to ESD ground
• Snaps to amt
  Low profile reduces snagging of clothes and work instruments
• Extra ring terminal included
  Allows for customizing cord length
• Available with or without a one megohm resistor
• Made in America

NOTE:

Per ESD 6.1 "Provisions may be made to include a resistor where it may be required for a purpose other than ESD."

ESD Handbook TR 20.20 paragraph 5.1.3 Basic Grounding Requirements "The first step in ensuring that everything in an EPA is at the same electrical potential is to ground all conductive components of the work area (worksurfaces, people, equipment, etc.) to the same electrical ground point. This point is called the common point ground. The next step in completing the ground circuit is to connect the common point ground to the equipment ground (third wire, green)"

One Megohm resistor is required in wrist straps, however, the recommended practice is hard ground per ANSI/EOS/ESD S6.1 that is no resistor between the common point ground terminal and a worksurface floor mat, or shelving. Per ANSI/ESD S20.20 Table 1 Grounding System Technical Requirement, the Recommended Range is less than 1 ohm AC impedance.