• Low profile
  Helps keep employees from tripping on cord connection
• 10mm (0.395") snap
  Easily snaps to 10mm mat socket snap, flush to mat surface
• Stud has threaded hole
  6-32x1/4" flat head screw and countersunk washer are provided
• Screw allows ground cord to be optionally bolted to mat
  Keeps cord from disconnecting and ensures proper grounding
• Fifteen feet of wire terminated
  With a #10 (.200") ring terminal
• Made in America

These items are primarily used for floor mats. They can also be used to ground bench mats and shelving. To plug in and ground wrist straps, please see our Common Point Ground Cords.

Closeout items are subject to a 90-day warranty for materials and workmanship. No credit will be issued. ESD Systems.com to approve exchange for similar items.

NOTE:

Per ESD 6.1 "Provisions may be made to include a resistor where it may be required for a purpose other than ESD."

ESD Handbook TR 20.20 paragraph 5.1.3 Basic Grounding Requirements "The first step in ensuring that everything in an EPA is at the same electrical potential is to ground all conductive components of the work area (worksurfaces, people, equipment, etc.) to the same electrical ground point. This point is called the common point ground. The next step in completing the ground circuit is to connect the common point ground to the equipment ground (third wire, green)"

One Megohm resistor is required in wrist straps, however, the recommended practice is hard ground per ANSI/EOS/ESD S6.1 that is no resistor between the common point ground terminal and a worksurface floor mat, or shelving. Per ANSI/ESD S20.20 Table 1 Grounding System Technical Requirement, the Recommended Range is less than 1 ohm AC impedance.